#930 Grow With Me Racer with Remote Control PCBA Swap

Follow the steps below to complete a PCBA Swap on your Grow with Me Racer

     Questions? Contact Customer Service for fast & friendly help. 

     Tools Needed: Flathead Screwdriver, Phillips Head Screwdriver

     Compatible Models: #930

 

TROUBLESHOOTING RESOURCES

1. Turn the car off and remove the seat. Place the remote to
   the side.
2. Disconnect the battery and remove the 2 screws holding it in
   place. Pull up on the battery to remove it from the car.
3. Remove 5 screws from the locations shown below.
4. Push the battery connector into the space under the seat.
5. Remove the seat by pulling up on the hole where the battery
   was with your right hand. Place your left hand over the mode
   selection switch. Do not press down with your left hand.
6. Locate the main circuit board under the seat tray. It is a
   rectangular green piece near the right motor.
7. Disconnect every connector going to the board, there will be
   7 to undo. Press on the latch and pull the connector away.
8. Remove the 2 screws holding the board down. Lift the board
   out of place

Does your new product have a missing or damage part? Submit a request for a replacement part under warranty here.

Does your older product need a refresh? Shop replacement parts here