eScooter Handlebar Tension Adjustment

Follow the steps below to adjust the tension on your scooter's handlebar.

     Questions? Contact Customer Service for fast & friendly help. 

     Tools Needed: 4mm Allen wrench

     Compatible Models: Flyer™ S533

STEP 1: Slide the locking sleeve up on the tube. Push the lever down while holding the tube upright to avoid sudden folding.

mceclip2.png

STEP 2: Once the scooter is folded, locate the bolt at the bottom of the tube. Use a 4mm allen wrench to tighten the bolt a quarter turn, clockwise. Doing this will increase the tension of the folding mechanism, resulting in more handlebar stability.

mceclip1.png

STEP 3: Return the scooter to the upright position and lock in place to check stability. Repeat
Step 2 until you reach a desired fit. Remember, the tighter the bolt, the higher the tension of the folding mechanism.

mceclip0.png
You're now ready to ride!

Was this article helpful?

1 out of 1 found this helpful

Have more questions? Submit a request

Comments

0 comments

Article is closed for comments.