eScooter Charger Port Replacement

Follow the steps below to replace your scooter's charger port.

     Questions? Contact Customer Service for fast & friendly help. 

     Tools Needed: Phillips Head Screwdriver

     Compatible Models: Flyer™ S533

STEP 1: Open the rubber cover to expose the charging port. Use a screwdriver to remove the 2 screws securing the port to the scooter.

STEP 2: Pull out the charger port assembly from the body. Make sure the connector is exposed from
within the deck. If you are unable to see the connector, see Step 3, if not proceed to Step 4. Disconnect the wire by pushing down on the lock tab. The charger port assembly should
come free from the scooter.

STEP 3: Connect the wire from the new charger port to the scooter. Feed the wire into the scooter until the charger port is flush with the deck.

STEP 4: Use a screwdriver to secure the new charger port in place with 2 screws. Push the rubber cover shut.

You're now ready to ride!